D-Link xStack DES-3528 Series Cli Reference Guide

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
135
DES-3528:admin# disable pvid auto_assign
Command: disable pvid auto_assign
Success.
DES-3528:admin#
show pvid auto_assign
Purpose
Used to show PVID auto-assigment state.
Syntax show pvid auto_assign
Description
This command is used to show PVID auto-assigment state.
Parameters
None.
Restrictions
None.
Example usage:
To display PVID auto-assignment state:
DES-3528:admin# show pvid auto_assign
Command: show pvid auto_assign
PVID Auto-assignment: Enabled.
DES-3528:admin#
config gvrp
Purpose
Used to configure the GVRP’s timer and its MAC address format for NNI ports when used in
Q-in-Q mode.
Syntax config gvrp [timer [join | leave | leaveall] < value 100-100000> | nni_bpdu_addr [dot1d |
dot1ad]]
Description
This command is used to set the GVRP’s timer and its MAC address format for NNI ports
when used in Q-in-Q mode. The default value for Join time is 200 milliseconds; for Leave
time is 600 milliseconds; for LeaveAll time is 10000 milliseconds.
Parameters
join − Specifies the Join time will be set
leave − Specifies the Leave time will be set
leaveall − Specifies the LeaveAll time will be set
value − The time value will be set. The value range is 100 to 100000 milliseconds. In
addition, the Leave time should greater than 2 Join times and the LeaveAll time should
greater than Leave time.
nni_bdpu_addr - Uses to determine the BPDU protocol address for GVRP in service provide
site. It can use 802.1d GVRP address or 802.1ad service provider GVRP address.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To set the Join time to 200 milliseconds:
DES-3528:admin# config gvrp timer join 200
Command: config gvrp timer join 200
Success.
DES-3528:admin#

D-Link xStack DES-3528 Series Specifications

General

Brand	D-Link
Model	xStack DES-3528 Series
Category	Switch
Language	English