xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
152
delete link_aggregation
Purpose
Used to delete a previously configured link aggregation group.
Syntax delete link_aggregation group_id <value 1-8>
Description
This command is used to delete a previously configured link aggregation group.
Parameters
<value 1-8> − Specifies the group ID. The Switch allows up to eight link aggregation groups
to be configured. The group number identifies each of the groups.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To delete link aggregation group:
config link_aggregation
Purpose
Used to configure a previously created link aggregation group.
Syntax config link_aggregation group_id <value 1-8> {master_port <port> | ports <portlist> |
state [enable | disable] }(1)
Description
This command allows users to configure a link aggregation group that was created with the
create link_aggregation command above.
Parameters
group _id <value 1-8> − Specifies the group ID. The Switch allows up to 8 link aggregation
groups to be configured. The group number identifies each of the groups.
master_p
ort <port
>
− Master port ID. Specifies which port (by port number) of the link aggregation group will be the master port. All of the ports in a link aggregation group will
share the port configuration with the master port.
ports <portlist> − Specifies a port or range of ports that will belong to the link aggregation
group.
state [enable | disable] − Allows users to enable or disable the specified link aggregation
group.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 with group members ports 5-7 plus port 9:
To Next Page
Loading...
Need help?
General