D-Link xStack DES-3528 Series

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
163
show address_binding dhcp_snoop
Purpose
This command is used to display the IP–MAC–Port Binding DHCP snooping.
Syntax show address_binding dhcp_snoop {max_entry {ports <portlist>}}
Description
This command is used to display the IP–MAC–Port Binding DHCP snooping.
Parameters max_entry – Specifies to display the maximum entry value.
ports – Specifies the list of ports used for this display.
Restrictions
None.
Example usage:
To display the IP–MAC–Port Binding DHCP snooping:
DES-3528:admin#show address_binding dhcp_snoop
Command: show address_binding dhcp_snoop
DHCP_Snoop(IPv4) : Disabled
DHCP_Snoop(IPv6) : Disabled
DES-3528:admin#
show address_binding dhcp_snoop binding_entry
Purpose
This command is used to display the DHCP snoop binding entries.
Syntax show address_binding dhcp_snoop binding_entry {port <port>}
Description
This command is used to display the DHCP snoop binding entries.
Parameters ports – Specifies the port used for this display.
Restrictions
None.
Example usage:
To display the DHCP snoop binding entries:
DES-3528:admin#show address_binding dhcp_snoop binding_entry
Command: show address_binding dhcp_snoop binding_entry
LT(Lease Time) ST(Status) - A:Active I:Inactive
IP Address MAC Address LT(sec) Port ST
--------------------------------------- ----------------- ---------- ----- --
Total Entries : 0
DES-3528:admin#