D-Link xStack DES-3528 Series - Page 199

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
199
Command Parameters
show mld_snooping mrouter_ports [vlan <vlan_name 32> | vlanid <vlanid_list> | all] {[static | dynamic |
forbidden]}
create mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>
delete mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>
config mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr> [add | delete]
<portlist>
show mld_snooping static_group {[vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>}
config mld_snooping
data_driven_learning
[max_learned_entry <value 1-1024> | vlan_name <vlan_name> | vlanid
<vlanid_list> | all] {state [enable | disable] | aged_out [enable | disable] |
expiry_time <sec 1-65535>}(1)
clear mld_snooping
data_driven_group
[all | [vlan_name <vlan_name> | vlanid <vlanid_list>] [<ipv6addr> | all]]
show mld_snooping statistic counter [vlan <vlan_name> | vlanid <vlanid_list> | ports <portlist>]
clear mld_snooping statistics counter
config mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> | no_limit]
show mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]
config igmp access_authentication
ports
[all | <portlist>] state [enable | disable]
show igmp access_authentication
ports
[all | <portlist>]
Each command is listed, in detail, in the following sections.