D-Link xStack DES-3528 Series

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
205
DES-3528:admin# create igmp_snooping static_group vlan default 239.1.1.1
Command: create igmp_snooping static_group vlan default 239.1.1.1
Success.
DES-3528:admin#
delete igmp_snooping static_group
Purpose
Used to delete a IGMP snooping multicast static group.
Syntax delete igmp_snooping static_group [vlan<vlan_name 32> | vlanid <vlanid_list>]
<ipaddr>
Description
The deletion of an IGMP snooping static group will not affect the IGMP snooping dynamic
member ports for a group.
Parameters vlan - Specify the name of the VLAN on which the router port resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the ID of the VLAN on which the router port resides.
<vlanid_list> - Enter the VLAN ID list here.
<ipaddr> - Specify the multicast group IP address.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To delete an IGMP snooping static group for VLAN 1, group 239.1.1.1:
DES-3528:admin# delete igmp_snooping static_group vlan default 239.1.1.1
Command: delete igmp_snooping static_group vlan default 239.1.1.1
Success.
DES-3528:admin#
config igmp_snooping static_group
Purpose
This command is used to configure the IGMP snooping static group.
Syntax config igmp_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>]
<ipaddr> [add | delete] <portlist>
Description
When a port is configured as a static member port, the IGMP protocol will not operate on this
port. For example, suppose that a port is a dynamic member port learned by IGMP. If this
port is configured as a static member later, then the IGMP protocol will stop operating on this
port. The IGMP protocol will resume once this port is removed from static member ports.
The static member port will only affect V2 IGMP operation.
Parameters vlan - Specify the name of the VLAN on which the static group resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the ID of the VLAN on which the static group resides.
<vlanid_list> - Enter the VLAN ID here.
<ipaddr> - Specify the multicast group IP address.
add - Specify to add the member ports.
delete - Specify to delete the member ports.
<portlist> - Specify a range of ports to be configured.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To unset port range 9-10 from IGMP snooping static member ports for group 239.1.1.1 on default VLAN: