To Next Page

To Previous Page

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide

235

show dhcp_relay

Purpose

Used to display the current DHCP/BOOTP relay configuration.

Syntax show dhcp_relay {ipif <ipif_name 12>}

Description

This command will display the current DHCP relay configuration for the Switch, or if an IP

interface name is specified, the DHCP relay configuration for that IP interface.

Parameters

ipif <ipif_name 12> − The name of the IP interface for which to display the current DHCP

relay configuration.

Restrictions

None.

Example usage:

To show the DHCP relay configuration:

DES-3528:admin#show dhcp_relay

Command: show dhcp_relay

DHCP/BOOTP Relay Status : Disabled

DHCP/BOOTP Hops Count Limit : 4

DHCP/BOOTP Relay Time Threshold : 0

DHCP Vendor Class Identifier Option 60 State: Disabled

DHCP Client Identifier Option 61 State: Disabled

DHCP Relay Agent Information Option 82 State : Disabled

DHCP Relay Agent Information Option 82 Check : Disabled

DHCP Relay Agent Information Option 82 Policy : Replace

DHCP Relay Agent Information Option 82 Remote ID : 00-22-B0-10-8A-00

Interface Server 1 Server 2 Server 3 Server 4

------------ --------------- --------------- --------------- ---------------

Server VLAN ID List

--------------- -----------------------------------------------------------

DES-3528:admin#

Example usage:

To show a single IP destination of the DHCP relay configuration:

DES-3528:admin#show dhcp_relay ipif System

Command: show dhcp_relay ipif System