xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
236
enable dhcp_relay
Purpose
Used to enable the DHCP/BOOTP relay function on the Switch.
Syntax enable dhcp_relay
Description
This command is used to enable the DHCP/BOOTP relay function on the Switch.
Parameters
None.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To enable DHCP relay:
disable dhcp_relay
Purpose
Used to disable the DHCP/BOOTP relay function on the Switch.
Syntax disable dhcp_relay
Description
This command is used to disable the DHCP/BOOTP relay function on the Switch.
Parameters
None.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To disable DHCP relay:
config dhcp_relay option_60 state
Purpose
This command is used to configure DHCP relay agent information option 60 state of the
Switch. Used to config dhcp_relay opton_60 state.
Syntax config dhcp_relay option_60 state [enable | disable]
Description
This command decides whether DHCP relay will process the DHCP option 60 or not. When
enabled, if packets do not have option 60, then the relay servers cannot be determined
based on option 60. Because the priority of option 60 and option 61 is higher than per IPIF
configured servers, if the relay servers are determined based on option 60 or option 61, then
per IPIF configured servers will be ignored. If the relay servers are determined neither by
option 60 nor option 61, then per IPIF configured servers will be used to determine the relay
servers.
Parameters enable – Enables the fuction.
disable – Disables the fuction.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure DHCP relay option 60 state:
To Next Page
Loading...
Need help?
General