D-Link xStack DES-3528 Series - Page 249

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
249
show 802.1x
Purpose
Used to display the 802.1X state or configurations.
Syntax show 802.1x { [auth_state | auth_configuration] ports {<portlist>} }
Description
This command displays the 802.1X state or configurations.
Parameters
auth_state − Used to display 802.1X authentication state information of some ports.
auth_configuration − Used to display 802.1X configurations of some ports.
portlist − Specifies a range of ports to be displayed.
Restrictions
None.
Example usage:
To display the 802.1X states:
DES-3528:admin# show 802.1x auth_state ports 1-3
Command: show 802.1x auth_state ports 1-3
Status: A - Authorized; U - Unauthorized; (P): Port-Based 802.1X;Pri-Priority
Port MAC Address RX VID PAE State Backend State Status VID Pri
----- -------------------- ------ -------------- ------------- ------ ---- ---
1 00-05-5D-F9-16-76 3 Authenticated Idle A - -
Total Authenticating Hosts :0
Total Authenticated Hosts :1
DES-3528:admin#
To display the 802.1X system level configurations:
DES-3528:admin#show 802.1x
Command: show 802.1x
802.1X : Disabled
Authentication Protocol : RADIUS_EAP
Forward EAPOL PDU : Disabled
Max User : no_limit
RADIUS Authorization : Enabled
DES-3528:admin#
To display the 802.1X configurations:
DES-3528:admin# show 802.1x auth_configuration ports 1
Command: show 802.1x auth_configuration ports 1
Port Number : 1
Capability : None
AdminCrlDir : Both
OpenCrlDir : Both
Port Control : Auto
QuietPeriod : 60 sec
TxPeriod : 30 sec
SuppTimeout : 30 sec
ServerTimeout : 30 sec
MaxReq : 2 times
ReAuthPeriod : 3600 sec
ReAuthenticate : Enabled
Forward EAPOL PDU On Port : Disabled
Max Users On Port : 16
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh