D-Link xStack DES-3528 Series - Page 255

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
255
config radius add
Purpose
Used to configure the settings the Switch will use to communicate with a RADIUS server.
Syntax config radius add <server_index 1-3> [<server_ip> | <ipv6addr>] key <passwd 32>
[default | {auth_port <udp_port_number 1-65535> | acct_port <udp_port_number 1-
65535> | timeout <int 1-255> | retransmit <int 1-20>}]
Description
This command is used to configure the settings the Switch will use to communicate with a
RADIUS server.
Parameters
<server_index 1-3> − Assigns a number to the current set of RADIUS server settings. Up to
three groups of RADIUS server settings can be entered on the Switch.
<server_ip> − The IP address of the RADIUS server.
<ipv6addr> - Enter the IPv6 address used here.
key − Specifies that a password and encryption key will be used between the Switch and the
RADIUS server.
<passwd 32> − The shared-secret key used by the RADIUS server and the Switch. Up to 32
characters can be used.
default − Uses the default UDP port number in the auth_port, acct_port, timeout and
retransmit parameters.
auth_port <udp_port_number 1-65535> − The UDP port number for authentication requests.
The default is 1812.
acct_port <udp_port_number 1-65535> − The UDP port number for accounting requests.
The default is 1813.
timeout <int 1-255> – The time in second for waiting for a server reply. Default value is 5
seconds.
retransmit <int 1-20> − The count for re-transmit. Default value is 2.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the RADIUS server communication settings:
DES-3528:admin# config radius add 1 10.48.74.121 key dlink default
Command: config radius add 1 10.48.74.121 key dlink default
Success.
DES-3528:admin#
config radius delete
Purpose
Used to delete a previously entered RADIUS server configuration.
Syntax config radius delete <server_index 1-3>
Description
This command is used to delete a previously entered RADIUS server configuration.
Parameters
<server_index 1-3> − Assigns a number to the current set of RADIUS server settings. Up to
3 groups of RADIUS server settings can be entered on the Switch.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To delete previously configured RADIUS server communication settings:
DES-3528:admin# config radius delete 1
Command: config radius delete 1
Success.
DES-3528:admin#