xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
256
config radius
Purpose
Used to configure the Switch’s RADIUS settings.
Syntax config radius <server_index 1-3> {ipaddress [<server_ip> | <ipv6addr>] | key <passwd
32> | auth_port [<udp_port_number 1-65535> | default] | acct_port [<udp_port_number
1-65535> | default] | timeout [<int 1-255> | default] | retransmit [<int 1-20> | default]}
Description
This command is used to configure the Switch’s RADIUS settings.
Parameters
<server_index 1-3> − Assigns a number to the current set of RADIUS server settings. Up to
three groups of RADIUS server settings can be entered on the Switch.
ipaddress <server_ip> − The IP address of the RADIUS server.
<ipv6addr> - Enter the IPv6 address used here.
key − Specifies that a password and encryption key will be used between the Switch and the
RADIUS server.
• <passwd 32> − The shared-secret key used by the RADIUS server and the Switch.
Up to 32 characters can be used.
auth_port <udp_port_number 1-65535> − The UDP port number for authentication requests.
The default is 1812.
acct_port <udp_port_number 1-65535> − The UDP port number for accounting requests.
The default is 1813.
timeout <int 1-255> – The time in second for waiting for a server reply. Default value is 5
seconds.
retransmit <int 1-20> − The count for re-transmit. Default value is 2.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the RADIUS settings:
show radius
Purpose
Used to display the current RADIUS configurations on the Switch.
Syntax show radius
Description
This command is used to display the current RADIUS configurations on the Switch.
Parameters
None.
Restrictions
None.
Example usage:
To display RADIUS settings on the Switch:
To Next Page
Loading...
Need help?
General