D-Link xStack DES-3528 Series Cli Reference Guide

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
282
Conform : Permit Replace DSCP: 11 Counter: Enabled
Exceed : Permit Replace DSCP: 22 Counter: Enabled
Violate : Drop Counter: Disabled
------------------------------------------------------------------------------
Profile ID:1 Aceess ID:2 Mode : srTCM
CIR(Kbps):2500 CBS(Kbyte):2000 EBS(Kbyte):3500
Action:
Conform : Permit Counter: Enabled
Exceed : Permit Replace DSCP: 33 Counter: Enabled
Violate : Drop Counter: Disabled
------------------------------------------------------------------------------
Profile ID:1 Aceess ID:3 Mode : Meter
Rate(Kbps):2000 Burst size(Kbyte):2000
Action:
Rate exceed : Drop
------------------------------------------------------------------------------
Total Entries: 3
DES-3528:admin#
config time_range
Purpose
Used to configure the range of time to activate a function on the Switch.
Syntax config time_range <range_name 32> [ hours start_time < time hh:mm:ss > end_time<
time hh:mm:ss > weekdays <daylist> | delete]
Description
This command defines a specific range of time to activate a function on the Switch by
specifying which time range in a day and which days in a week are covered in the time
range. Note that the specified time range is based on SNTP time or configured time. If this
time is not available, then the time range will not be met.
Parameters
range_name − Specifies the name of the time range settings.
start_time − Specifies the starting time in a day. (24-hr time)
For example, 19:00 means 7PM. 19 is also acceptable. start_time must be smaller than
end_time.
end_time − Specifies the ending time in a day. (24-hr time)
weekdays − Specify the list of days contained in the time range. Use a dash to define a
period of days. Use a comma to separate specific days.
For example, mon-fri (Monday to Friday)
sun, mon, fri (Sunday, Monday and Friday)
delete − Deletes a time range profile. When a time_range profile has been associated with
ACL entries, the delete of this time_range profile will fail.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To config time range:
DES-3528:admin# config time_range 1-3_new hours start_time 11:21:20 end_time 11:44:40
weekdays mon-fri
Command: config time_range 1-3_new hours start_time 11:21:20 end_time 11:44:40
weekdays mon-fri
Success.
DES-3528:admin#

D-Link xStack DES-3528 Series Specifications

General

Brand	D-Link
Model	xStack DES-3528 Series
Category	Switch
Language	English