D-Link xStack DES-3528 Series - Page 281

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
281
config flow_meter
<value 0-63> - Enter the replace DSCP value here.
drop - Drops the packet.
counter - (Optional) Specifies the ACL counter. This is optional. The default is “disable”. The
resource may be limited so that a counter cannot be turned on. Counters will be cleared
when the function is disabled.
enable - Specifies that the ACL counter option will be enabled.
disable - Specifies that the ACL counter option will be disabled.
violate - Specifies the action when a packet is mapped to the “red” color.
permit - Permits the packet.
replace_dscp - Changes the DSCP of the packet.
<value 0-63> - Enter the replace DSCP value here.
drop - Drops the packet.
counter - (Optional) Specifies the ACL counter. This is optional. The default is “disable”. The
resource may be limited so that a counter cannot be turned on. Counters will be cleared
when the function is disabled.
enable - Specifies that the ACL counter option will be enabled.
disable - Specifies that the ACL counter option will be disabled.
delete - Deletes the specified flow_meter.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the ACL flow meter on the Switch:
DES-3528:admin# config flow_meter profile_id 1 access_id 1 tr_tcm cir 1000 cbs 200 pir
2000 pbs 2000 exceed permit replace_dscp 21 violate drop
Command: config flow_meter profile_id 1 access_id 1 tr_tcm cir 1000 cbs 200 pir 2000
pbs 2000 exceed permit replace_dscp 21 violate drop
Success.
DES-3528:admin#
show flow_meter
Purpose
Used to view the current state of ACL flow meter on the Switch.
Syntax show flow_meter {[profile_id <value 1-14> | profile_name <name 1-32>] {access_id
<value1-128>}}
Description
This command is used view the current state of ACL flow meter on the Switch.
Parameters
profile_id <value 1-14> − Specifies the profile ID.
profile_name <name 1-32> − Specifies the name of the profile. The maximum length is 32
characters.
access_id <value1-128> − Specifies the access ID.
Restrictions
None.
Example usage:
To show the ACL flow meter state on the Switch:
DES-3528:admin# show flow_meter
Command: show flow_meter
Flow Meter Information
------------------------------------------------------------------------------
Profile ID:1 Aceess ID:1 Mode : trTCM
CIR(Kbps):1000 CBS(Kbyte):2000 PIR(Kbps):2000 PBS(Kbyte):2000
Action: