D-Link xStack DES-3528 Series - Page 296

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
296
enable loopdetect
Purpose
Used to globally enable loop-back detection on the Switch.
Syntax enable loopdetect
Description
This command is used to globally enable loop-back detection on the Switch.
Parameters
None.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To enable loop-back detection on the Switch:
DES-3528:admin# enable loopdetect
Command: enable loopdetect
Success
DES-3528:admin#
disable loopdetect
Purpose
Used to globally disable loop-back detection on the Switch.
Syntax disable loopdetect
Description
This command is used to globally disable loop-back detection on the Switch.
Parameters
None.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To disable loop-back detection on the Switch:
DES-3528:admin# disable loopdetect
Command: disable loopdetect
Success
DES-3528:admin#
show loopdetect
Purpose
Used to display the current loop-back detection settings on the Switch.
Syntax show loopdetect
Description
This command is used to display the current loop-back detection settings on the Switch
Parameters
None.
Restrictions
None.
Example usage:
To show loop-detect: