D-Link xStack DES-3528 Series - Page 297

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
297
DES-3528:admin#show loopdetect
Command: show loopdetect
LBD Global Settings
---------------------------
Status : Disabled
Mode : Port-based
Interval : 10 sec
Recover Time : 60 sec
Trap State : None
Log State : Enabled
Function Version : 4.04
DES-3528:admin#
show loopdetect ports
Purpose
Used to display the current per-port loop-back detection settings on the Switch.
Syntax show loopdetect ports {<portlist>}
Description
This command is used to display the current per-port loop-back detection settings on the
Switch
Parameters
<portlist> − Specifies a range of ports for the loop-back detection
Restrictions
None.
Example usage:
To show loop-detect ports:
DES-3528:admin# show loopdetect ports 1-3
Command: show loopdetect ports 1-3
Port LoopDetect State Loop Status
------ ------------------ ----------
1 Enabled Normal
2 Enabled Normal
3 Enabled Normal
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
config loopdetect log state
Purpose
This command is used to configure the log state for LBD.
Syntax config loopdetect log state [enable | disable]
Description
This command is used to configure the log state for LBD. The default value is enabled.
Parameters enable - Enable the LBD log feature.
disable - Disable the LBD log feature. All LBD-related logs will not be recorded.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command
Example usage:
To enable the log state for LBD:
DES-3528:admin#config loopdetect log state enable
Command: config loopdetect log state enable
Success.