xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
349
disable ssh
Purpose
Used to disable SSH.
Syntax disable ssh
Description
This command allows users to disable SSH on the Switch.
Parameters
None.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Usage example:
To disable SSH:
config ssh authmode
Purpose
Used to configure the SSH authentication mode setting.
Syntax config ssh authmode [password | publickey | hostbased] [enable | disable]
Description
This command will allow users to configure the SSH authentication mode for users
attempting to access the Switch.
Parameters password – This parameter may be chosen if the administrator wishes to use a locally
configured password for authentication on the Switch.
publickey − This parameter may be chosen if the administrator wishes to use a publickey
configuration set on a SSH server for authentication.
hostbased − This parameter may be chosen if the administrator wishes to use a host
computer for authentication. This parameter is intended for Linux users requiring SSH
authentication techniques and the host computer is running the Linux operating system with
a SSH program previously installed.
[enable | disable] − This allows users to enable or disable SSH authentication on the Switch.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To enable the SSH authentication mode by password:
To Next Page
Loading...
