xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
394
config lldp port
Purpose
Used to configure an individual port or group of ports to exclude one or more of IEEE 802.1
Organizationally protocol identity TLV data types from outbound LLDP advertisements.
Syntax config lldp ports [<portlist> | all] dot1_tlv_ protocol_identity [all | {eapol | lacp | gvrp |
stp }(1)] [enable | disable]
Description
This TLV optional data type indicates whether the corresponding Local System's Protocol
Identity instance will be transmitted on the port. The Protocol Identity TLV provides a way for
stations to advertise protocols that are important to the operation of the network. Such as
Spanning Tree Protocol, the Link Aggregation Control Protocol, and numerous vendor
proprietary variations are responsible for maintaining the topology and connectivity of the
network. If EAPOL, GVRP, STP(including MSTP), and LACP protocol identity is enabled on
this port and it is enabled to be advertised, then this protocol identity will be advertised.
Parameters <portlist> – Use this parameter to define ports to be configured.
all – Use this parameter to set all ports in the system.
dot1_tlv_protocol_identity – This TLV optional data type indicates whether the corresponding
Local System's Protocol Identity instance will be transmitted on the port. The Protocol
Identity TLV provides a way for stations to advertise protocols that are important to the
operation of the network. Such as Spanning Tree Protocol, the Link Aggregation Control
Protocol, and numerous vendor proprietary variations are responsible for maintaining the
topology and connectivity of the network. If EAPOL, GVRP, STP(including MSTP), and LACP
protocol identity is enabled on this port and it is enabled to be advertised, then this protocol
identity will be advertised. The default state is disabled.
eapol - Specifies that the Dot1 TLV protocol identity will be set to EAPOL.
lacp - Specifies that the Dot1 TLV protocol identity will be set to LACP.
gvrp - Specifies that the Dot1 TLV protocol identity will be set to GVRP.
stp - Specifies that the Dot1 TLV protocol identity will be set to STP.
all - Specifies that the Dot1 TLV protocol identity will be set to all.
enable - Specifies that the Dot1 TLV protocol identity will be enabled.
disable - Specifies that the Dot1 TLV protocol identity will be disabled.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure exclude the protocol identity TLV from the outbound LLDP advertisements for all ports:
To Next Page
Loading...
Need help?
General