clear wac auth_state
Purpose
Used to clear the authentication state of a port.
Syntax clear wac auth_state [ports [<portlist> | all] {authenticated | authenticating | blocked}
| macaddr <macaddr>]
Description
This command is used to clear the authentication state of a port. The port will return to an
un-authenticated state. All the timers associated with the port will be reset.
Parameters <portlist> – Specifies the list of ports whose WAC state will be cleared.
all – Specifies all the ports whose WAC state will be cleared.
authenticated – Specifies to delete the host in this state.
authenticating – Specifies to delete the host in this state.
blocked - Specifies to delete the host in this state.
macaddr – Specifies the MAC address used.
<macaddr> - Enter the MAC address used here.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To clear the WAC authenticated state:
To Next Page
Loading...
