D-Link xStack DES-3528 Series Cli Reference Guide

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
465
config ethernet_oam ports critical_link_event
Purpose
Used to configure Ethernet OAM critical link event.
Syntax config ethernet_oam ports [<portlist> | all ] critical_link_event [ dying_gasp |
critical_event ] notify_state [enable | disable]
Description
This command is used to configure the capability of Ethernet OAM critical link event. If the
capability for an event is disabled, the port will never send out the corresponding critical link
event.
Parameters portlist – Specifies a range of ports to be configured. Use all to specify all ports.
dying_gasp – An unrecoverable local failure condition has occurred.
critical_event – An unspecified critical event has occurred.
notify_state – Specifies to enable or disable the event notification. The default state is
enable.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To configure dying_gasp event for port 1:
DES-3528:admin# config ethernet_oam ports 1 critical_link_event dying_gasp
notify_state enable
Command: config ethernet_oam ports 1 critical_link_event dying_gasp notify_state
enable
Success.
DES-3528:admin#
config ethernet_oam ports remote_loopback
Purpose
Used to start or stop Ethernet OAM remote loop-back .
Syntax config ethernet_oam ports [<portlist> | all ] remote_loopback [start | stop]
Description
This command is used to start or stop the remote peer to enter the Ethernet OAM remote
loop-back mode.
To start the remote peer to enter the remote loop-back mode, you must ensure the port is in
active mode and the OAM connection is established. If the local client is already in remote
loop-back mode, then it cannot apply this command.
Parameters portlist – Specifies a range of ports to be configured. Use all to specify all ports.
remote_loopback – If start is specified, it will request the peer to change to the remote loop-
back mode. If stop is specified, it will request the peer to change to the normal operation
mode.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To start remote loop-back on port 1:
DES-3528:admin# config ethernet_oam ports 1 remote_loopback stop
Command: config ethernet_oam ports 1 remote_loopback stop
Success.
DES-3528:admin#

D-Link xStack DES-3528 Series Specifications

General

Brand	D-Link
Model	xStack DES-3528 Series
Category	Switch
Language	English