D-Link xStack DES-3528 Series - Page 466

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
466
config ethernet_oam ports received_remote_loopback
Purpose
Used to configure the method to process the received Ethernet OAM remote loop-back
command.
Syntax config ethernet_oam ports [<portlist> | all ] received_remote_loopback [process |
ignore ]
Description
This command is used to configure the client to process or to ignore the received Ethernet
OAM remote loop-back command.
In remote loop-back mode, all user traffic will not be processed. Ignoring received remote
loop-back command will prevent the port from entering remote loop-back mode.
Parameters portlist – Specifies a range of ports to be configured. Use all to specify all ports.
received_remote_loopback – Specifies whether to process or to ignore the received Ethernet
OAM remote loop-back command The default method is”ignore”.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the method of processing the received remote loop-back command as “process” on port 1:
DES-3528:admin# config ethernet_oam ports 1 received_remote_loopback process
Command: config ethernet_oam ports 1 received_remote_loopback process
Success.
DES-3528:admin#