D-Link xStack DES-3528 Series - Page 468

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
468
Remote Loopback : Supported
Unidirection : Supported
Link Monitoring : Supported
Variable Request : Not Supported
PDU Revision : 0
Operation Status : Disable
Loopback Status : No Loopback
There is no peer entry information exist.
Port 2
Local Client
-----------------------------------------------------------
OAM : Disabled
Mode : Active
Max OAMPDU : 1518 Bytes
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
show ethernet_oam ports configuration
Purpose
Used to display Ethernet OAM configuration.
Syntax show ethernet_oam ports {<portlist>} configuration
Description
This command is used to show port’s Ethernet OAM configurations.
Parameters portlist – Specifies a range of ports to display.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To show Ethernet OAM configuration on port 1-2:
DES-3528:admin# show ethernet_oam ports 1-2 configuration
Command: show ethernet_oam ports 1-2 configuration
Port 1
-----------------------------------------------------------
OAM : Enabled
Mode : Passive
Dying Gasp : Enabled
Critical Event : Enabled
Remote Loopback OAMPDU : Processed
Symbol Error
Notify State : Enabled
Window: : 1000 milliseconds
Threshold : 2 Errored Symbol
Frame Error
Notify State : Enabled
Window: : 1000 milliseconds
Threshold : 2 Errored Frame
Frame Period Error
Notify State : Enabled
Window: : 1000000 Frames
Threshold : 10 Errored Frame
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All