D-Link xStack DES-3528 Series - Page 469

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
469
show ethernet_oam ports statistics
Purpose
Used to show Ethernet OAM statistics.
Syntax show ethernet_oam ports {<portlist>} statistics
Description
This command is used to show ports Ethernet OAM statistics information.
Parameters portlist – Specifies a range of ports to display.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To show port 1 OAM statistics:
DES-3528:admin# show ethernet_oam ports 1 statistics
Command: show ethernet_oam ports 1 statistics
Port 1
-----------------------------------------------------------
Information OAMPDU Tx : 0
Information OAMPDU Rx : 0
Unique Event Notification OAMPDU Tx : 0
Unique Event Notification OAMPDU Rx : 0
Duplicate Event Notification OAMPDU Tx: 0
Duplicate Event Notification OAMPDU Rx: 0
Loopback Control OAMPDU Tx : 0
Loopback Control OAMPDU Rx : 0
Variable Request OAMPDU Tx : 0
Variable Request OAMPDU Rx : 0
Variable Response OAMPDU Tx : 0
Variable Response OAMPDU Rx : 0
Organization Specific OAMPDUs Tx : 0
Organization Specific OAMPDUs Rx : 0
Unsupported OAMPDU Tx : 0
Unsupported OAMPDU Rx : 0
Frames Lost Due To OAM : 0
DES-3528:admin#
show ethernet_oam event_log
Purpose
Used to show the Ethernet OAM event log.
Syntax show ethernet_oam {<portlist>} event_log {index <value_list> }
Description
This command is used to show ports Ethernet OAM event log information. The Switch can
buffer 1000 event logs. The event log is different from sys-log. It provides more detailed
information than sys-log. Each OAM event will be recorded in both OAM event log and
system log.
You can specify an index to show a range of events.
Parameters portlist – Specifies a range of ports to display.
index – Specifies an index range to display.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To show port 1 external OAM event:
DES-3528:admin# show ethernet_oam ports 1 event_log
Command: show ethernet_oam ports 1 event_log
Port 1
-----------------------------------------------------------------
Event Listing
Index Type Location Time Stamp
----- ------------------------ ------------- ---------------------