D-Link xStack DES-3528 Series - Page 524

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
524
MSTP : Enable
ACL : Disable
CLI : Enable
SNMP : Disable
IGMP : Enable
DES-3528:admin#
debug config state
Purpose
Use the command to set the state of the debug.
Syntax debug config state [enable | disable]
Description
Use the command to set the state of the debug.
Parameters enable - Enable the debug state.
disable - Disable the debug state.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To set the debug state to disabled:
DES-3528:admin# debug config state disable
Command: debug config state disable
Success.
DES-3528:admin#
debug error_reboot show state
Purpose
Use the command to show the error reboot status.
Syntax debug error_reboot show state
Description
Use the command to show the error reboot status.
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To show the error reboot status:
DES-3528:admin# debug error_reboot show state
Command: debug error_reboot show state
Error Reboot: Enable
DES-3528:admin#