xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
542
Current Ring State : Idle
------------------------
R-APS VLAN : 4093
Ring Status : Enabled
West Port : Virtual Channel
East Port : 10 (Forwarding)
RPL Port : None
RPL Owner : Disabled
Protected VLANs : 200-220
Ring MEL : 2
Holdoff Time : 0 milliseconds
Guard Time : 500 milliseconds
WTR Time : 5 minutes
Current Ring State : Idle
------------------------
Total Ring: 2
DES-3528:admin# show erps raps_vlan 4092 sub_ring
Command: show erps raps_vlan 4092 sub_ring
R-APS VLAN: 4092
Sub-Ring R-APS VLAN TC Propagation State
------------------- ---------------------
4093 Enable
config erps trap
Purpose
This command is used to configure trap state of ERPS events.
Syntax config erps trap [enable | disable]
Description
This command is used to configure trap state of ERPS events.
Parameters trap - Specifies to enable or disable the ERPS trap state.
enable - Enter enable to enable the trap state.
disable - Enter disable to disable the trap state. The default value is disabled.
Restrictions
Only Administrator, Operator and Power User-level users can issue this command.
Example usage:
To configure the trap state of the ERPS:
DES-3528:admin# config erps trap enable
Command: config erps trap enable
Success.
To Next Page
Loading...
Need help?
General