D-Link xStack DES-3528 Series - Page 61

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
61
DES-3528:admin#
disable snmp authenticate_traps
Purpose
Used to disable SNMP authentication trap support.
Syntax disable snmp authenticate_traps
Description
This command is used to disable SNMP authentication support on the Switch.
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To disable the SNMP authentication trap support:
config snmp system_contact
Purpose
Used to enter the name of a contact person who is responsible for the Switch.
Syntax config snmp system_contact <sw_contact>
Description
This command is used to enter the name and/or other information to identify a contact
person who is responsible for the Switch. A maximum of 255 character can be used.
Parameters
<sw_contact> − A maximum of 255 characters is allowed. A NULL string is accepted if there
is no contact.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the Switch contact to “MIS Department II”:
DES-3528:admin# config snmp system_contact MIS Department II
Command: config snmp system_contact MIS Department II
Success.
DES-3528:admin#
config snmp system_location
Purpose
Used to enter a description of the location of the Switch.
Syntax config snmp system_location <sw_location>
Description
This command is used to enter a description of the location of the Switch. A maximum of 255
characters can be used.
Parameters
<sw_location> − A maximum of 255 characters is allowed. A NULL string is accepted if there
is no location desired.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the Switch location for “HQ 5F”:
DES-3528:admin# config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
DES-3528:admin# disable snmp authenticate_traps
Command: disable snmp authenticate_traps
Success.
DES-3528:admin#