42 • Camera Features Linea HS Series Camera User's Manual
Active Settings for Current Operation
Active settings are those settings used while the camera is running and include all unsaved
changes made by GenICam input to the settings.
These active settings are stored in the module’s volatile memory and will be lost and cannot be
restored if the module resets, is powered down or loses power during operation.
To save these settings so that they can be restored next time you power up the modules or to
protect against losing them in the case of power loss, you must save the current settings using the
user set save parameter. Once saved, the current settings become the selected user set.
User Setting
The user setting is the saved set of camera configurations that you can customize, resave, and
restore. By default, the user settings are shipped with the same settings as the factory set.
The command user set save saves the current settings to non-volatile memory as a user set. The
module automatically restores the user set configured as the default set when it powers up.
To restore a saved user set, set the user set selector to the set you want to restore and then select
the user set load parameter.
Factory Settings
The factory setting is the modules settings that were shipped with the module and which load
during the camera’s first power-up. To load or restore the original factory settings, at any time,
select the factory setting parameter and then select the user set load parameter.
Default Setting
Either the factory or one of the user settings can be used as the default setting, by selecting the
set to use in the user set default selector. The chosen set automatically becomes the default
setting and is the set loaded when the camera is reset or powered up.
To Next Page
Loading...
Need help?
General