Dalsa A CIS Series - Acquisition and Transfer Control Category; Acquisition and Transfer Control Feature Descriptions; Figure 24: Acquisition & Transfer Control Panel

Linea HS Series Camera User's Manual Appendix A: GenICam Commands • 65
Acquisition and Transfer Control Category
The Acquisition and Transfer controls, as shown by CamExpert, has parameters used to configure
the optional acquisition modes of the device.
Figure 24: Acquisition & Transfer Control Panel
Acquisition and Transfer Control Feature Descriptions
Display Name
Feature
Description
View
Acquisition Mode
AcquisitionMode
The device acquisition mode defines the number of frames to
capture during an acquisition and the way it stops
Beginner
Continuous
Continuous
Only continuous mode is currently available.
Acquisition Start
AcquisitionStart
Commands the camera to start sending image data. (WO)
Beginner
Acquisition Stop
AcquisitionStop
Commands the camera to stop sending image data at the end of the
current line (WO)
Beginner
Acquisition Status
AcquisitionStatus
Reads the acquisition state.
Beginner
Acquiring
Acquiring
Currently acquiring and sending image data.
Not Acquiring
NotAcquiring
Currently not acquiring or sending image data.