Dalsa A CIS Series User Manual

Linea HS Series Camera User's Manual Appendix A: GenICam Commands • 63
Transport Layer Control Category
The Transport Layer Control category, as shown by CamExpert, has parameters used to configure
features related to the CLHS Connection.
Figure 23: Transport Layer Panel
Transport Layer Feature Descriptions
Display Name
Feature
Description
View
XML Major Version
DeviceManifestXMLMajorVersion
Together with DeviceManifestXMLMinorVersion
specifies the GenICam™ feature description XML
file version (RO)
Beginner
XML Minor Version
DeviceManifestXMLMinorVersion
Together with DeviceManifestXMLMajorVersion
specifies the GenICam™ feature description XML
file version (RO)
Beginner
CLHS Discovery
clhsDiscovery
Selects whether the camera needs to be
commanded to send image data after power up.
Disable CLHS Discovery if not implemented in the
frame grabber.
Beginner
DFNC
Discovery Disabled
DiscoveryDisable
CLHS transmitters are enabled immediately on
power up.
Discovery Enabled
DiscoveryEnable
CLHS transmitters enable after sending Acquisition
start.
Next CLHS Device
Configuration
clhsNextDeviceConfig
When the camera is next powered up, the specified
CLHS lane configuration will be set for the camera.
Beginner
DFNC
One Cable Five Lanes
OneCableOneLanes
TwoCablesTwoLanes
Refresh GenCP
Status
refreshGenCPStatus
Press to update the GenCP Status.
Beginner
DFNC
Last GenCP Status
genCPStatus
If a feature read or write returns that it fails, read
this feature to get the actual reason for the failure
Returns the last error. Reading this feature clears
it. Sapera only.
Beginner
DFNC

Dalsa A CIS Series Specifications

General

Brand	Dalsa
Model	A CIS Series
Category	Security Sensors
Language	English