Parameter 32-11 User Unit Denominator
Table 1122: Parameter 32-11 User Unit Denominator
32-11 User Unit Denominator
Parameter type: Range, 1 - 1073741823
Change during operation: True
All target positions are made in user units and are converted to quad-counts internally. By selecting scaling units, it is possible to
work with any measurement unit (for example mm). This factor consists of a numerator and denominator.
Parameter 32-12 User Units Numerator
Table 1123: Parameter 32-12 User Units Numerator
32-12 User Units Numerator
Parameter type: Range, 1 - 1073741823
Change during operation: True
All target positions are made in user units and are converted to quad-counts internally. By selecting scaling units, it is possible to
work with any measurement unit (for example mm). This factor consists of a numerator and denominator.
Parameter 32-13 Enc.2 Control
Table 1124: Parameter 32-13 Enc.2 Control
Default value: [0] No soft changing
Change during operation: True
Enables bump-less changing of feedback encoder in software while running and setting position to 0 without loosing the actual
position.
Encoder soft changing enable
Encoder soft changing and soft zero enable
Parameter 32-14 Enc.2 Node ID
Table 1125: Parameter 32-14 Enc.2 Node ID
Parameter type: Range, 1 - 127
Change during operation: True
AU275636650261en-000101 / 130R0334 | 591Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide
To Next Page
Loading...
Need help?
General