To Next Page

To Previous Page

Q3-40 Fan functions Q3-41 Pump functions Q3-42 Compressor functions

Parameter 22-60 Broken Belt Function Parameter 22-20 Low Power Auto Set-up Parameter 1-03 Torque Characteristics

Parameter 22-61 Broken Belt Torque Parameter 22-21 Low Power Detection Parameter 1-71 Start Delay

Parameter 22-62 Broken Belt Delay Parameter 22-22 Low Speed Detection Parameter 22-75 Short Cycle Protection

Parameter 4-64 Semi-Auto Bypass Set-up Parameter 22-23 No-Flow Function Parameter 22-76 Interval between Starts

Parameter 1-03 Torque Characteristics Parameter 22-24 No-Flow Delay Parameter 22-77 Minimum Run Time

Parameter 22-22 Low Speed Detection Parameter 22-40 Minimum Run Time Parameter 5-01 Terminal 27 Mode

Parameter 22-23 No-Flow Function Parameter 22-41 Minimum Sleep Time Parameter 5-02 Terminal 29 Mode

Parameter 22-24 No-Flow Delay Parameter 22-42 Wake-up Speed [RPM] Parameter 5-12 Terminal 27 Digital Input

Parameter 22-40 Minimum Run Time Parameter 22-43 Wake-up Speed [Hz] Parameter 5-13 Terminal 29 Digital Input

Parameter 22-41 Minimum Sleep Time Parameter 22-44 Wake-up Ref./FB Dierence Parameter 5-40 Function Relay

Parameter 22-42 Wake-up Speed [RPM] Parameter 22-45 Setpoint Boost Parameter 1-73 Flying Start

Parameter 22-43 Wake-up Speed [Hz] Parameter 22-46 Maximum Boost Time Parameter 1-86 Trip Speed Low [RPM]

Parameter 22-44 Wake-up Ref./FB Dierence Parameter 22-26 Dry Pump Function Parameter 1-87 Trip Speed Low [Hz]

Parameter 22-45 Setpoint Boost Parameter 22-27 Dry Pump Delay –

Parameter 22-46 Maximum Boost Time Parameter 22-80 Flow Compensation –

Parameter 2-10 Brake Function Parameter 22-81 Square-linear Curve Approxi-

mation

–

Parameter 2-16 AC brake Max. Current Parameter 22-82 Work Point Calculation –

Parameter 2-17 Over-voltage Control Parameter 22-83 Speed at No-Flow [RPM] –

Parameter 1-73 Flying Start Parameter 22-84 Speed at No-Flow [Hz] –

Parameter 1-71 Start Delay Parameter 22-85 Speed at Design Point [RPM] –

Parameter 1-80 Function at Stop Parameter 22-86 Speed at Design Point [Hz] –

Parameter 2-00 DC Hold/Preheat Current Parameter 22-87 Pressure at No-Flow Speed –

Parameter 4-10 Motor Speed Direction Parameter 22-88 Pressure at Rated Speed –

– Parameter 22-89 Flow at Design Point –

– Parameter 22-90 Flow at Rated Speed –

– Parameter 1-03 Torque Characteristics –

– Parameter 1-73 Flying Start –

Table 2.5 Q3-4 Application Settings

How to Programme

VLT

HVAC Drive FC 102

Danfoss vlt FC 102 Programming Guide

Other manuals for Danfoss vlt FC 102