3.4. Main Menu
The Main Menu gives access to all parameters.
1. To enter the Main Menu, press
[MENU] key until indicator in display
is placed above
Main Menu
.
2. Use [▲] [▼] to browse through the
parameter groups.
3. Press [OK] to select a parameter
group.
4.
Use [▲] [▼] to browse through the
parameters in the specific group.
5. Press [OK] to select the parameter.
6. Use [▲] [▼] to set/change the pa-
rameter value.
7. Press [OK] to accept the value.
8. To exit, press either [Back] twice to
enter
Quick Menu
, or press [Menu]
once to enter
Status
.
Illustration 3.10: Indicating Main Menu mode
3. Programming VLT Micro Drive FC 51
12
MG.02.C2.02 - VLT
®
is a registered Danfoss trademark
3
To Next Page
Loading...
