Counter cannot be reset.
15-06 Reset kWh Counter
Option: Function:
This parameter cannot be selected via serial port RS 485.
[0]
*
Do Not Reset Counter is not reset.
[1] Reset Counter Counter is reset.
15-07 Reset Running Hours Counter
Option: Function:
This parameter cannot be selected via serial port RS 485.
[0]
*
Do Not Reset Counter is not reset.
[1] Reset Counter Counter is reset.
4.12.4. 15-3* Fault Log
This parameter group contains a fault log showing reasons for the ten latest trips.
15-30 Fault Log: Error Code
Range: Function:
0 [0 - 255] View error code and look it up in VLT Micro Design Guide.
4.12.5. Drive Identification, 15-4*
Parameters containing read only information about the hardware and software configuration of
the frequency converter.
15-40 FC Type
Option: Function:
View FC type.
15-41 Power Section
Option: Function:
View power section of frequency converter.
15-42 Voltage
Option: Function:
View voltage of frequency converter.
15-43 Software Version
Option: Function:
View software version of frequency converter.
VLT Micro Drive FC 51 4. Parameter Descriptions
MG.02.C2.02 - VLT
®
is a registered Danfoss trademark
69
4
To Next Page
Loading...
