Danfoss VLT FC 51 Series User Manual

16-11 Power [hp]
Range: Function:
0 hp [0 - 99 hp ] View output power in hp.
16-12 Motor Voltage
Range: Function:
0.0
*
[0.0 - 999.9 V] View motor phase voltage.
16-13 Frequency
Range: Function:
0.0 Hz
*
[0.0 - 400.0 Hz] View output frequency in Hz.
16-14 Motor Current
Range: Function:
0.00 A
*
[0.00 - 1856.00 A] View motor phase current.
16-15 Frequency [%]
Range: Function:
0.00
*
[-100.00 - 100.00%] View a two-byte word reporting actual motor frequency as a
percentage of par. X-XX
16-18 Motor Thermal
Range: Function:
0%
*
[0 - 100%] View calculated thermal motor load as percentage of estimated
thermal motor load.
4.13.4. 16-3* Drive Status
Parameters for reporting the status of the frequency converter.
16-30 DC Link Voltage
Range: Function:
0 V
*
[0 - 10000 V] View DC-link voltage.
16-34 Heat Sink Temp.
Range: Function:
0
*
[0 - 255] View heat sink temperature of frequency converter.
16-35 Inverter Thermal
Range: Function:
0%
*
[0 - 100%] View calculated thermal load on frequency converter in relation
to estimated thermal load on frequency converter.
4. Parameter Descriptions VLT Micro Drive FC 51
72 MG.02.C2.02 - VLT
®
is a registered Danfoss trademark
4

Danfoss VLT FC 51 Series Specifications

General

Enclosure	IP20
Operating Temperature	-10°C to +40°C (without derating), up to +50°C (with derating)
Output Voltage	0 to input voltage
Protection Features	Overcurrent, overvoltage, undervoltage, short circuit, overload, overtemperature, ground fault
Cooling Method	Forced convection
Input Voltage	200-240V AC, 380-480V AC