3.1.4 Decoupling Plate 48
4 How to Order
49
4.1 Configuration
49
4.2 Ordering Numbers
51
5 How to Install
54
5.1 Mechanical Dimensions
54
5.1.1 Adjustable Frequency Drive Dimensions 54
5.1.2 Shipping Dimensions 57
5.2 Electrical Data
58
5.2.1 Electrical Installation in General 59
5.2.2 Connecting to Line Power and Motor 60
5.2.3 Fuses and Circuit Breakers 67
5.2.5 Control Terminals 72
6 How to Program
73
6.1 Programming with MCT 10 Set-up Software
73
6.2 Local Control Panel (LCP)
73
6.3 Menus
74
6.3.1 Status Menu 74
6.3.2 Quick Menu 74
6.3.3 Start-up Wizard for Open-loop Applications 74
6.3.4 Main Menu 84
6.4 Quick Transfer of Parameter Settings between Multiple Adjustable Frequency
Drives
84
6.5 Readout and Programming of Indexed Parameters
84
6.6 Initialize the Adjustable Frequency Drive to Default Settings in Two Ways
85
7 RS-485 Installation and Set-up
86
7.1 RS-485
86
7.1.1 Overview 86
7.1.2 Network Connection 86
7.1.3 Adjustable Frequency Drive Hardware Set-up 87
7.1.4 Adjustable Frequency Drive Parameter Settings for Modbus Communica-
tion 87
7.1.5 EMC Precautions 88
7.2 Adjustable Frequency Protocol Overview
88
7.3 Network Configuration
88
7.4 FC Protocol Message Framing Structure
89
Contents Design Guide
Danfoss A/S © Rev. 2014-01-14 All rights reserved. MG18C522
To Next Page
Loading...
Need help?
General