Page 101
OP-01622, OP-01672 Supply Error
The printer cannot identify the supply material in the laminator.
Possible Cause 1: You have installed a roll of laminator supply material that
is not supported by the printer.
Solution 1: Make sure the new type of supply material is Datacard-certified
supply material. Run the latest Firmware Update Utility to install support for
the new type of supply material in this printer.
Possible Cause 2: You have installed a defective roll of laminator supply
material.
Solution 2: Install another roll of laminator supply material.
If you cannot fix the problem, contact your service provider for assistance.
Related Topics:
"Loading laminator supply material" on page 9
To Next Page
Loading...
Need help?
General
