Page 52
Printer messages
The SP75 Card Printer with the Built-in Ethernet displays messages on the LCD panel.
Messages (that match up with printer messages) also appear on the PC in message boxes. You might see
messages on the LCD panel that do not appear on the PC, because the LCD displays all printer messages while
the Smart Driver shows the most important message if a group of messages occurs at the same time. In addition,
the Smart Driver can display messages that begin in the driver (not the printer) and those messages do not
appear on the LCD panel.
When a message appears on the LCD panel, do the following:
1 Find the message number in this section. Messages are
listed in numerical order.
2 Use the cause and solution information to fix the problem.
3 Make sure cards are loaded and the ribbon is in the
printer. Close the printer cover (if it was opened).
4 Resume printing:
— Click a button on the message box on the PC, which
might allow you to retry the card.
— Press the Ready key on the LCD panel to clear the
message and cancel printing of the card.
5 If another message is displayed, repeat steps 1 through 4.
If not, the printer returns to the ready or busy state.
To Next Page
Loading...
Need help?
General
