DataCard SP75 - OP-01612, OP-01662 Card Jam

Page 89
OP-01612, OP-01662 Card Jam
A card is stuck in the laminator.
Possible Cause 1: A card is stuck in the laminator.
Solution 1a: Turn the Laminator Advance Knob to move the card (A). You
can turn the knob in both directions.
Solution 1b: If it is difficult to turn the Laminator Advance Knob or you hear
clicks when you turn it, remove the laminator cartridge (B). Pull firmly to
remove the cartridge. Turn the Laminator Advance Knob again (A) to move
the card.
Solution 1c: If the card will not move, power off the printer and allow it to
cool down. Pull the card out.
Tips for Success:
• If cards get stuck often, run a cleaning card, change the cleaning sleeve,
and then clean the rollers in the printer.
• If you are using topcoat in one or both laminators, run a laminator
cleaning card. See Production in SP Series Info Central for the steps to
follow.
• If you are running a laminator cleaning card, this message can appear
when you place the card under the white stripe in the output hopper.
Push the card in farther and start the laminator cleaning card again.