Page 47
Run a laminator cleaning card
Tips for Success
• Run a laminator cleaning card only to remove particles of holographic or clear topcoat. If you do not use
topcoat material in your printer, you do not need to run a laminator cleaning card.
• The laminator cleaning card has adhesive on both sides; it is different from the printer cleaning card. See
Cleaning the Laminator in SP Series Info Central for more information.
1 With “Diagnostics” displayed on line 1, press the Up or Down Arrow key if needed
to display “Lam Clean Card” on line 2.
2 Remove the protective paper from both sides of the card.
3 Press the Enter key to start the cleaning routine. The Ready light blinks green.
4 Place the card in the output hopper as shown.
To Next Page
Loading...
