EasyManuals Logo

DataCard SP75 User Manual

DataCard SP75
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
Page 67
SY-01327 Data Error
The request sent to the printer is not supported.
Possible Cause 1: The printer features (such as magnetic stripe or an L2
laminator) have changed. The driver Printer Toolbox, Properties, or Printing
Preferences dialog box has not changed to remove settings that are not
supported by the printer and you have chosen and applied a setting that the
printer does not support.
Solution 1: Close the driver Properties or Printing Preferences dialog box
and open it again to display the settings for the printer. On the Printer
Toolbox, wait until “The printer type is SP75.” appears before using buttons
or settings in the Printer Toolbox, Printer Diagnostics, or the Properties or
Printing Preferences dialog boxes.
Possible Cause 2: For a directly networked printer, the message “A printer
has been identified. (DR 00921)” was displayed on the PC and the OK or
Close button was used. After that, you used the Printer Toolbox,
Diagnostics, or the Properties or Printing Preferences dialog box before
settings were updated for this printer.
Solution 2: Do not close the message box. Follow the instruction to wait
until the message box closes on its own. If you are using Printer Diagnostics,
close it and wait until the message box closes on its own.

Table of Contents

Other manuals for DataCard SP75

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DataCard SP75 and is the answer not in the manual?

DataCard SP75 Specifications

General IconGeneral
BrandDataCard
ModelSP75
CategoryPrinter
LanguageEnglish

Related product manuals