Page 70
MS-01401, MS-01402, MS-01403 Mag Stripe Data
Data sent does not match requirements for track 1, 2, or 3.
Possible Cause 1: Data sent includes more characters than allowed by the
magnetic stripe format selected for the track.
Solution 1: Cancel the current print job. Determine the magnetic stripe
format for the track. Change the data to be encoded, make sure the
application is set to the same format as the track, and resend the print job.
Possible Cause 2: Data sent includes characters not allowed by the
magnetic stripe format selected for the track.
Solution 2: Cancel the current print job. Determine the magnetic stripe
format for the track. Change the data to be encoded, make sure the
application is set to the same format as the track, and resend the print job.
If you cannot fix the problem, contact your service provider for assistance.
To Next Page
Loading...
Need help?
General
