Page 10
— Make sure the supply material is between the guides on both the take-
up and supply sides of the cartridge.
6 Close the laminator cartridge gate.
7 Pinch both sides of the gate and cartridge together to close.
8 Replace the loaded laminator cartridge in the printer.
Tips for Success
• Make sure the laminate follows the path shown.
• Change the supply in one laminator at a time.
• Load the L1 laminator cartridge to the correct location in the printer.
• Do not load material upside down, or it will be applied to the heated roller.
To Next Page
Loading...
Need help?
General
