Datalogic AV900 User Manual

BI-DIRECTIONAL SETUP
PRODUCT REFERENCE GUIDE 365
“Indicate Active Configuration” can only be enabled on one camera in the tunnel. The
exception is a “Backup Controller”. It can be enabled on the “Primary” and “Second-
ary” controllers if redundancy is being used.
Inactive state on the selected “Input” will force “Primary Configuration”
Active state on the selected “Input” will force “Secondary Configuration”
The “Input X” used will not allow “Debounce”, “Active State”, “Leading Offset” or
“Trailing Offset” to be configured is set to “Indicate Active Configuration”
The first time “Indicate Active Configuration” is enabled the current XML will be copied
to both primary and secondary configurations
If “Indicate Active Configuration” is disabled the camera tunnel will use the last config-
uration (primary or secondary) but no longer update the primary/secondary XML. The
change to disable “Indicate Active Configuration” will not be written to either the pri-
mary or secondary XML.
Enabling “Indicate Active Configuration” after it had already been enabled once will
result in the current XML being overwritten with the selected configuration (primary or
secondary)
Enabling “Indicate Active Configuration” on another camera (after disabling the current
camera) will result in the current XML being overwritten with the selected configura-
tion (primary or secondary)
The current configuration being used will be displayed in the top right corner of each
page.

Datalogic AV900 Specifications

General

Brand	Datalogic
Model	AV900
Category	Digital Camera
Language	English