Product Reference Guide
193
Chapter F
Host Commands
Accepting RS-232 Commands
The scanner responds to the following RS-232 commands:
If one of the above commands is received, the scanner will perform the steps indicated for the command. Host
commands for other interfaces are also available. Contact Tech Support for more details.
COMMAND ASCII HEX COMMENT
Enable Scanner E 0x45
Disable
Scanner
D0x44
Reset Scanner R 0x52
Not On File
Indication
F 0x46 Long series of beeps
Beep Good
Read Tone
B 0x42 Beeps if Good Read Beep is enabled
Force Good
Read Tone
! 0x01 Beeps regardless of beep setting
Bel ‘ 0x07 Force Good Read Tone
Identification
request
i0x69
Returns long response
a
a. Call Tech Support for information.
Health request h 0x68
Returns long response
a
Status request s 0x73
Returns long response
a
To Next Page
Loading...
