Datalogic Magellan 1100i Product Reference Guide

Cell Phone Mode
Product Reference Guide 29
Cell Phone in Target Mode
This feature sets the reader’s Cell Phone Mode when it is in Target Mode:
No Cell Phone Mode — Will not read cell phone labels when in Target Mode.
Auto Detection Cell Phone Mode — Automatically detects cell phone labels and shifts to
Cell Phone Mode when in Target Mode.
Always Enter Cell Phone Mode — The reader will always enter Cell Phone Mode whenever
it is in Target Mode.
Follow these instructions to configure this feature:
1. Determine which mode is desired from the selections above.
2. Scan the START barcode to place the scanner in Programming Mode.
3. Scan the two barcodes which configure the desired mode.
4. Scan the END barcode.
NOTE
This feature is only available when Cell Phone Mode is enabled.
START / END
PROGRAMMING BARCODES
Cell Phone in Target Mode = No Cell Phone Mode
[This is the DEFAULT setting]
No Cell Phone Mode #1
No Cell Phone Mode #2

Datalogic Magellan 1100i Specifications

General

Yaw reading angle	-75 - 75 °
Decoding standards	-1D + GS1 DataBar, -GS1 DataBar Composites, -GS1 DataBar Expanded Stacked, -GS1 DataBar Stacked, -GS1 DataBar Stacked Omnidirectional, -MicroPDF417, -PDF417.
Tilt reading angle	0 - 360 °
Pitch reading angle	-65 - 65 °
Standard interfaces	USB, RS-232
Input voltage	4.5 - 14 V
Power consumption	400 mA
Dimensions (WxDxH)	84 x 71 x 94 mm
Product color	Black
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Weight	198.5 g