SOFTWARE CONFIGURATION
7.5.2 Restore
To perform a Restore:
1. From the DL.CODE Device menu, select either Single Reader Restore (from file on PC);
or Restore from external storage device.
NOTE: For ID-NET network Restore (Master only), select the Internal
Network replacement selection.
If restoring an ID-NET network though the Master, this may take a few minutes.
At the end of the restore, DL.CODE shows a message indicating successful completion.
7.5.3 Replacement
CAUTION: The replacement device must be the exact same model as the
device it is replacing.
The Restore function also provides easy and secure Single Device Replacement:
1. Remove the device to be replaced.
2. Connect the new device (make sure the new device has been previously set to factory
default).
3. Run the Restore procedure by selecting either Single Reader Restore (from file on PC)
or Restore from external storage device item (see: Restore procedure).
NOTE: In case of Backup or Restore operation failures, error messages will
be displayed in the Monitor Diagnostic page.
To Next Page
Loading...