Datalogic Matrix 210N - BM150 DISPLAY MODULE CONFIGURATION

MATRIX 210N™ REFERENCE MANUAL
134
7
7.9 BM150 DISPLAY MODULE CONFIGURATION AND MESSAGES
The BM150 display module is an optional accessory for the CBX500 connection box.
Although independent, it is an extension of the reader's HMI Interface, so through its keypad
it provides execution of HMI features such as Test, Focus/Locate, Calibration and Code
Setting. It also displays device status information, reading results, diagnostic and network
messages. Since it connects through the BM100 backup memory module, it provides access
to Backup and Restore features through its Extended menu.
7.9.1 Configuration Through DL.CODE
BM150 must be detected through the BM100 backup memory module at power-up/reset and
this is done through a command setting in DL.CODE. By connecting the reader to DL.CODE
the following parameters can be managed.
In the Device>Settings>Settings>Maintenance window:
 Enable BM100 Detection
Checked (Enabled): the BM100 backup memory module will be detected on power-
up/reset; therefore the BM150 display module (if present), will also be enabled.
Unchecked (Disabled): the BM100 backup memory module will not be detected on
power-up/reset; therefore the BM150 display module (if present), will also not be
enabled.
 BM150 Display Layout (Master Only)
Reading Mask Only: the Reading Mask screen is sent to the BM150 display.
Reading Mask/Device State: the Reading Mask/Device State screen is sent to the
BM150 display.
7.9.2 Accessing the HMI Interface Through Keypad and Display Menu
Through its keypad and display, the BM150 provides a remote extension of the reader's HMI
Interface. The HMI default menu items can be accessed as well as the View menu for Master
devices and the Extended menu for Backup and Restore functions.
To enter the Main Menu press the Up and Down
buttons simultaneously.
Up Enter Down
The menu structure is shown below.
Figure 88 – BM150 Keypad
Main Menu:
1. [Exit] (exits HMI Interface menu)
2. Test Mode (performs Test mode)
3. Focus/Locate (performs Focus function: turns on Blue Diamonds and laser pointers)
4. Calibration (performs Setup function)
5. Code Setting (performs Learn function)
6. Match Code Tra…(Training: allows reading a code and storing it as the Match code)