Datalogic Matrix 210N - CBX ELECTRICAL CONNECTIONS

MATRIX 210N™ REFERENCE MANUAL
58
4
4 CBX ELECTRICAL CONNECTIONS
The Matrix 210N can be directly connected to a CBX connection box.
We recommend making system connections through one of the CBX connection boxes since
they offer the advantages of easy connection, easy device replacement and filtered
reference signals.
NOTE: If you require direct wiring to the reader the details of the connector
pins and relative connections are indicated in Appendix A.
The table below gives the pinout of the CBX100/500 terminal block connectors. Use this
pinout when the Matrix 210N reader is connected by means of the CBX100/500:
CBX100/500 Terminal Block Connectors
Input Power
Vdc
Power Supply Input Voltage +
GND
Power Supply Input Voltage -
Earth
Protection Earth Ground
Inputs
+V
Power Source – External Trigger
I1A
External Trigger A (polarity insensitive)
I1B
External Trigger B (polarity insensitive)
-V
Power Reference – External Trigger
+V
Power Source – Inputs
I2A
Input 2 A (polarity insensitive)
I2B
Input 2 B (polarity insensitive)
-V
Power Reference – Inputs
Outputs
+V
Power Source - Outputs
-V
Power Reference - Outputs
O1+
Output 1 +
O1-
Output 1 -
O2+
Output 2 +
O2-
Output 2 -
Auxiliary Interface
TX
Auxiliary Interface TX
RX
Auxiliary Interface RX
SGND
Auxiliary Interface Reference
ID-NET
REF
Network Reference
ID+
ID-NET network +
ID-
ID-NET network -
Shield
Network Cable Shield
Main Interface
RS232
RS422 Full-Duplex
TX
TX+
RX
*RX+
-
TX-
-
*RX-
SGND
SGND
* Do not leave floating, see par. 4.2.2 for connection details.