Datalogic Matrix 210N - BACKUP AND RESTORE VIA DL.CODE

SOFTWARE CONFIGURATION
127
7
7.5 BACKUP AND RESTORE THROUGH DL.CODE
DL.CODE allows Backup and Restore to be performed to/from the configuration PC via file or
to an external storage device such as BM100/BM150.
DL.CODE provides complete backup and restore functions (Configuration and Environmental
parameters) with the following difference:
For Single Readers or individual ID-NET Slaves:
 Backup and Restore functions provide parameter storage including all configuration jobs
present on the reader.
For Master Readers in ID-NET Master/Slave networks:
 Backup and Restore functions provide parameter storage of only the Startup
Configuration for the Master and all Slaves present in the network.
CAUTION: For Master/Slave networks any other configurations (jobs) stored
in the device memory will not be backed up. Therefore upon a restore, all jobs
other than the startup configuration will be overwritten (erased). It is strongly
recommended to save all configurations to backup files.
The Slaves must always be configured with the same network baudrate as the Master
for correct functioning including performing Backup and Restore procedures.
When performing Backup and Restore to/from file, device firmware can be included.
Regardless of the reader's network configuration, Backup to and Restore from external
device is supported by DL.CODE for any reading device when connected to:
 CBX + BM100
 QLM-Series Gateways
NOTE: Before executing a Backup to a BM100 backup module make sure
the Write Protection switch is set to Unlocked.