Datalogic PowerScan PD9530

Enter/Exit Programming Mode
222 PowerScan™ PD9530/PBT9500/PM9500
Date-Time Separator
Sets the character used to separate Date and Time from the next field in
message.
DEFAULT
$CRFTD0000\r
Disable Date-Time Separator
$CRFTD01\r
Set Character Separator =
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left follow
ed by 2 digits from the Alphanumeric charac-
ters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and no
t
save the entry string. You can then start again
at the beginning.
~
CANCEL