Shift No Actions Configured
Configure Actions for Shift
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code for
the Function Key you want to prog
ram. Next scan 4 dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
.
The first digit must be 0; the following 3 digits must be
co
nfigured according to the CMD_ID numbers in
Table 27 on page 253
. End by scanning the
ENTER/EXIT bar code again.
Enter/Exit Programming Mode
256
PowerScan™ PD9530/PBT9500/PM9500
Configure Actions for Shift (16-key models only)
To Next Page
Loading...
