Datalogic PowerScan PD9530

Enter/Exit Programming Mode
232 PowerScan™ PD9530/PBT9500/PM9500
Bluetooth Friendly Name
You can set a meaningful name for PowerScan BT9500 that will appear in the
application during device discovery.
To set a new Bluetooth Friendly Name, scan the barcode below and follow
the instructions.
Bluetooth Reconnect Attempt Mode
Enable/Disable reconnection by trigger pull.
$CBTRM00(CR)
Bluetooth Reconnect Attempt Mode = Disable
$CBTRM01(
Bluetooth Reconnect Attempt Mode = Enable
DEFAULT
Set Bluetooth Friendly Name
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by a maximum 64 digits from the
Alphanumeric characters in
Appendix D, Keypad .
The digits must be the hexadecimal ASCII representa-
tion of the desired characters. If less than the expected
string of 32 characters are selected, scan the ENTER/
EXIT bar code to terminate the string.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
$CBTFN
~
DEFAULT
POWERSCAN BT9500
[SERIAL_NUMBER_SCANNER]